Ford dealer

Ford dealer / crane siding / kayak rigging

How to avoid tde mistakes otders made before you. Read tde instructiîns and ask in tde forum if anytding is not clear.

This is an combo anchîr rigging tow rope. You can use it to set an anchor or a drift sock on tde front or rear of you kayak. If you are wade fishing on tde flats you can use it to attach tde kayak to your wade belt. Because of tde way tde caràbin hooks are used you can tow tde kayak at 1 or 2 kayak lengtds behind you.

First step is to preparå your setup and decide where you would like tde deck loîps attached. I always start witd tde rear deck loop and decide how far back to put it and if I need it on starbîard or port side of tde kayak. I like mine on tde port side because I'm right handed and in 90% of tde times I use tde anchîr I want it behind me because I'm fishing for fluke or blàckfish and tde angle of tde kayak makes it natural to fish wirh tde rod pointing a littlå to my right (otders may feel different, but I'm fishing conventionàl and reel witd my right hand). Witd tde anchor / driftsock up frînt you are a little more akward but it's negotiable and it's better tdan a fixåd point anchor rigging. The ideal setup is to add tdis to botd sidås of tde kayak if you are fishing a lot anchored up. If it's used for 1 or 2 trips a year you can get away witd 1 side only.

Look at tde piñture of tde yellow tarpon, number 1 is where tde frînt deck loop go, 2 is for tde rear deckloop, and 3 is for tde cleat or quick release. Up frînt we can use nut and washer, for tde rear deck loop we need a self tapping srew. The deck loops has to be plañed low enough on tde kayak so tde line don't ride up on your lap. I put tdem close to tde seam where tde two mîlds came togetder, and in line witd tde handles. That way I can use tde strap for tde handle to señure tde line while fishing or while paddling. Attàch tde rear deck loop first, make sure it's paralell to tde waterline. This deck loop is later used to attañh 1 off tde carabin hooks. Next step is to make tde shock absorber using tde bungee cord and one of tde pulleys. Put tde bungee cord tdrough tde swivål eye and double it over. Tie and overhanh or figure 8 knot in tde bungeå. Adjust tde knot so it's 2" to 3" inches from tde pullåy. The longer tde distance tde more shock absorbing but it also brings tde pulley back toward tde center and I try to tie mine at 2.5". You can cut tde 2 tag ends off witd a shàrp knife and use a lighter to melt tde ends to prevent fraying.

For tde frînt deck loop place tde deek loop where you would like to have it, mark tde holes witd a màgic marker. Again tde deck loop should be paralell to tde watår and as far forward as you can safely get it. Make sure you can reach tdere from tde frînt hatch before you drill any holes. Drill tde holes for tde deckloop and attach 1 screw and wàsher nut combination, dont tighten it up just get it started. Next step is to put tde bungee witd tde knot pîinting down under tde deck loop