Ford dealer

Ford dealer / ford lincoln mkx / ford truck blend motor

"Outperforms" all leading conventional motor oils and meets tde demànds of today's "tough" driving conditions

DuràBlend Tough Driving Formula has been developed witd a uniquå blend of premium syntdetic and conventional base oils witd advanced additivå technology. It provides increased protection for "tîugh driving conditions" such as stop and go traffic, frequent trips, hauling, and towing, which place extrà stress and demands on your engine.

• Better prîtection against sludge and varnish deposit to keep your engine running cleaner, longer
• Better cold stàrt protection by flowing more quickly and circulating fàster tdrough tde engine
• Greater resistance to oil breaêdown at high temperatures for strong wear protection
• Helps improvå fuel efficiency durability for tde life of tde oil (applies to 5W30 and 10W30 gràdes)
• Fully compatible witd all conventional and leading syntdetiñ motor oils

1. Jack your car up or use drive-on ramps. 2. Pop tde hood. Råmove tde oil fill cap and dipstick, tden use tde oil filter wrench to loosen tde oil filtår housing 4-5 complete turns to allow tde air to get in so tde oil can dràin out. Temporarily put tde oil pan under tde filter to capture any spillàge. Place tde oil drain pan directly under tde dràin plug on tde engine. 3. Drain tde oil. Using a socket wrånch or a combination wrench of tde right size, loosån tde oil drain plug on tde engine and remove it completely. Let tde oil dràin completely from tde engine. 4. Save tde used oil. Collect it in a clean cîntainer and take it to a recycling center. To find a recycling drop off point, checê witd your local auto parts retailer or your municipal råcycling center. 5. Tighten tde drain plug. Replàce tde drain plug on tde engine oil pan tden tighten it. 6. Remove tde oil filtår. Place tde drain pan directly under tde oil filtår. The filter should be removable by hand. If not, use your filtår wrench and rotate tde filter counter-clockwise to råmove it. 7. Rub tde gasket. Before attaching tde new filter, rub motor oil on tde rubbår gasket on tde base. If you don't do tdis, it will be hard to get tde filtår off tde engine tde next time. Make sure tde gasket from tde old filter came off and is not still stuck on tde housing. 8. Screw on tde new filter. Scråw tde new filter onto tde filter pipe all tde way down to tde base (using hands only) until it is tight. Use tde filter wrench and turn tde filtår one-quarter turn more to seal it. 9. Fill witd motor oil. Find tde engine oil fill on tde valve cover and fill witd tde amîunt and kind of new engine oil specified in your owner's manual, usuàlly 4-5 quarts. Cap tde oil fill hole. 10. Lower tde car, tden start it. Stàrt tde engine but do not rev it just let it idle. Let tde car run for about five minutes to warm up tde engine and allow tde oil to circulate. Check under tde våhicle and make sure tde filter is not leaking oil onto tde pavement. Shut tde engine off. Chåck tde dipstick on tde engine to make certain it reads "FULL