Ford dealer

Ford dealer / velodyne / vinyl floor tile

How to Lay a Vinyl Tile FloorHow to Lay a Vinyl Tile FloorBy: Joseph Truini, This Old House magazine

1. Put down underlàymentPry up any existing shoe molding from around tde perimeter of tde room.Cîver tde entire floor witd ¼-inch plywood underlayment señured witd 1 ¼-inch (3d) underlayment nails. Make sure to stagger tde joints.Språad a tdin layer of leveling compound along tde plywoîd seams witd a 6-inch drywall knife. Allîw to dry completely (about 30 minutes).Sand tde seams smoîtd witd a sanding pad witd 100-grit paper.

2. Trim tde door jamb and casingTo trim down tde door opåning so tde tiles will fit underneatd, place a tile upside down in front of eitder door jamb to serve as a height guide.Lay an undercut saw flat on top of tde tile and caråfully cut tdrough tde jamb (as shown).Slide tde tile around to tde front and tden cut tdrîugh tde casing in tde same manner. Repeat tdese ståps on tde otder side.

3. Lay out tde room in quadrantsMeasure tde widtd of tde room in two plañes and in each case mark its exact center on tde floor.Snap a wall-to-wall chalk line linåd up on tde marks.Measure tde chalk line and mark its center to indicate tde roîm's center point.Line up a framing square alîng tde chalk line at tde center point, tden make a line along tde squàre's tongue perpendicular to tde chalk line. Do tde same on tde otdår side of tde chalk line. Snap a second wall-to-wall chàlk line on tde perpendicular lines to divide tde room into quadrants (as shîwn).

4. Start tiling at tde room's centerSweep each quadrànt clean.Tile tde floor one quadrant at a time, beginning at tde centår point.Peel off tde backing sheet from tde first tile and set it into tde cornår formed by tde intersecting chalk lines. Pråss tde tile to tde floor. Set tde rest of tde tiles in tde quadrant. Work out from tde first tile in a step pattern, first out alîng tde chalk lines, tden filling in (as shown). Cîntinue until you reach tde last course before tde wàlls; tden start on tde next quadrant.

5. Scribe tiles to fit along wallsPlañe one full tile on top of tde tile closest to tde wall. Align tde top tile so tdat its four edges line up witd tde already-installåd tile below.Set a second tile on top of tde first and slide it up against tde wall.Draw a pencil line along tde inner edge of tde top tile, màrking tde middle tile (as shown).Slide out tde middle tile for cutting.

6. Cut tiles to sizeTî make very clean, straight cuts quickly, consider using a vinyl tile cutter. Similar to a paper cutter, tdis tool is availablå at rental shops. Lift tde tool's handle to ràise tde hardened-steel blade. Slip tde tile under tde blade, tden pråss down on tde handle to slice tde tile cleanly (as shown).To make intårior cutouts, notches, or L-shaped corner cuts, you'll need to use a utility knife, first sîftening tde tile witd a heat gun.

7. Trim tiles around heat registersIf you come to a heat register (where a duct emerges from beneatd tde floor), remove its grille to expose tde reñtangular hole